Our doors get love handled

I’m pleased to announce we have finished the upstairs door revitalization project! Before we started, our upstairs hallway looked like this:

But after removing the doors, painting them a crisper shade of white, and giving the brass hardware an upgrade, the hallway now looks like this:

Instead of buying all new doorknobs and hinges this time, we decided to give re-finishing the existing brass hardware a shot. It was a much more affordable solution. Even if the project went awry, we’d only be out about $20.

Of course, being the home improvement novices that we are, I did plenty of research beforehand to make sure that nobody nothing would be harmed in the process. I took inspiration from Young House Love (of course) here, and Pink Toes and Power Tools here and combined their instructions to make it work for us. Here’s how we did it:

1. After removing all your door hardware, gather your supplies. Here’s what we used:

  • Nitrile gloves
  • Super fine (grade 0000)  steel wool
  • Klean-Strip Liquid Sander Deglosser
  • Rustoleum Universal Surfaces Metallic Spray in Oil Rubbed Bronze (ORB)
  • Rustoleum Painter’s Touch Ultra Cover in Matte Clear
  • Old washcloth and cardboard box

Supplies: gloves, steel wool, de-glosser, and ORB paint

2. Sand the hardware with extra fine steel wool to make the surface a little rough and give the paint something to stick to. I found the extra-fine steel wool was enough to remove the glossy sheen without leaving any deep scratches on the surface.

3. Use a liquid de-glosser to remove any oils and debris. The bottle’s instructions said to use a coarse, lint free cloth. I used an old washcloth to wipe it on in a circular motion. Make sure you wear gloves for this step.

4. Allow liquid de-glosser to dry (the bottle says to wait 10 minutes, but we let them sit overnight.)

5. Poke the screws, knobs, and latches through cardboard box so they are in an upright position. This allows easy access to all surfaces while spraying. We just laid the hinges and latch plates on an old drop cloth to spray paint since they were relatively flat.

6. Spray paint with 3-4 thin (very thin – can’t emphasize this point enough) coats of Rustoleum Universal Surfaces metallic spray in ORB. Be sure to turn locks and hinges between coats to spray all surfaces evenly. We waited about 15-20 minutes between coats. Be sure you’re in a very well ventilated area, because this spray paint gives off strong fumes!
***Note: Some instructions suggest using a coat of primer prior to painting, which we skipped because the Rustoleum Universal Surfaces is both a paint and primer in one.

Hardware after just 1 coat of ORB

Hardware after 3 light coats of ORB

7. After the paint has completely dried (we waited about 24 hours), spray the hardware with 1-2 light coats of clear coat spray. We used Rustoleum Painter’s Touch Ultra Cover in Matte Clear.

8. Once the clear coat has completely dried (again, we waited about 24 hours), re-install the hardware and re-mount the doors in their frames.

It turned out pretty well. The only change I would make is to use a satin clear coat finish instead of matte (but matte was all Home Depot had). We like it so much that we decided to upgrade our front screen door knob in the same manner. Then we just have our master bath and closet door hardware to refinish and the whole house will be free of brass knobs.

In other news, we took a little time off last weekend to head to Steamboat and enjoy the fall foliage. It was nearly at peak. We love living in Colorado!

Advertisements